JoyeTech Cubis Coils-1.0ohm

Joyetech Cubis coils deliver maximum airflow and vapor production. The Joyetech Cubis 1.0ohm SS316L coils are made with stainless steel wire allowing you can use your device in both wattage mode and temperature control model. They also tend to last a bit longer and can be used under high wattage.  The Cubis Coils will satisfy vapers looking for a Mouth to lung ("MTL") draw. A MTL draw is commonly associated with how a tobacco cigarette is smoked.  It is when a user draws the vapour into their mouth first and then inhales it into their lungs.

Please Note:  Joyetech Cubis 1.0ohm SS316L coils have a stainless steel heating element which means these coils can run in both wattage and temperature SS mode.

Includes:

1 x Pack of Joyetech Cubis coils 1.0ohm SS316L recommended wattage is 10-25W (5pcs/pkg)

Compatible with:

Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.

Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.

Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.

Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.